Ghost Controls Gate Repair in San Lorenzo, CA

Ghost Controls Gate Repair in San Lorenzo, CA

If your Ghost Controls gate opener is acting up in San Lorenzo, we can usually diagnose it same-day. We’re an independent service provider working on Ghost Controls swing and slide operators throughout the 94580 ZIP, and what makes our work here different is simple: we know that most Ghost Controls failures in this town trace back to the original 1940s and 50s gate posts set in adobe clay with no concrete underneath. That local pattern, plus our brand-specific training, means we find the real cause faster than a generalist. Call (833) 593-6430 and we’ll get a technician out to your San Lorenzo property.

Call (833) 593-6430

Key takeaways:

• We repair Ghost Controls swing, slide, and battery backup systems across San Lorenzo
• We carry genuine Ghost Controls boards and motors, plus high-cycle aftermarket hardware where it outperforms OEM
• Most San Lorenzo Ghost Controls failures we see are caused by leaning posts, wet winters, or old batteries, not the motor itself
• Free estimates, with the price quoted and agreed before any work starts

Why San Lorenzo Residents Choose Us for Ghost Controls Service

We only do gates. That’s the whole business. Not fences, not general contracting, not handyman work. Every Ghost Controls operator we open up, we’ve seen a version of it before, and we carry parts for the common failures so we don’t have to order and wait. Our team works on Ghost Controls specifically, which means we know the TSS1 single swing, the TDS2 dual swing, the TSL1 slide operator, and the solar and battery backup systems well enough to quote a repair before we even show up, in most cases.

Gerardo Kendrick grew up in the Decoto neighborhood of Union City, where sliding iron gates were on half the driveways and the other half needed help after every storm. He learned electrical and mechanical systems at Chabot College in Hayward, then spent years doing hands-on gate work across the East Bay. What he found early is that no two installations act the same, even two doors down from each other. That’s why we treat every San Lorenzo gate as its own job, not another ticket. A gate that almost works is just a wall with a bad attitude.

For Ghost Controls sales & service, we’re the crew that reads the manual, opens the housing, and finds what’s actually wrong. We don’t replace control boards on a hunch. If your San Lorenzo gate is glitching after rain, we start with the post, the hinge, and the limit settings before we ever quote a board.

Common Ghost Controls Gate Repair Problems We Solve in San Lorenzo

• Control board corrosion from wet winters. Moisture wicks into outdoor enclosures during San Lorenzo’s rainy months and shorts the board. You’ll see the gate open randomly, refuse to close, or go completely dead. We open the housing, check for moisture damage and corroded terminals, and replace with a genuine Ghost Controls board if needed.
• Limit switch drift on swing operators. Wooden gates in San Lorenzo swell in winter and shrink in summer. That swelling nudges the gate arm out of alignment, so the operator stops mid-travel or reverses for no reason. We recalibrate the limits and adjust the arm, and if the post underneath is leaning, we address that too, because recalibrating a gate on a shifting post is a temporary fix.
• Battery backup failure after repeated charge cycles. Older batteries lose reserve capacity, so during a PG&E outage the gate won’t move. We see this a lot in San Lorenzo’s older tracts where the backup was installed years ago and never cycled properly. We test the battery under load and replace with a high-cycle aftermarket unit when the OEM spec is no longer worth the cost.
• Keypad and remote pairing dropouts. UV-degraded wire insulation and corroded connections at the operator are the usual culprits here. The wiring sits in the marine-layer fog and hot summer sun cycle, and connectors corrode faster than the manufacturer ever expected. We trace the wiring harness, clean or replace terminals, and re-pair your remotes and keypads.
• Operators mounted on original fence posts with no concrete footing. This is the San Lorenzo signature failure. The post leans after heavy rain, the gate drags or binds, and the operator trips its safety reverse or burns out the motor trying to push a gate that physically can’t move. We re-set the post, rehang the gate, and recalibrate. Then the Ghost Controls opener works the way it should.

Ghost Controls Service in San Lorenzo: What Local Conditions Mean for Your Equipment

Most Ghost Controls operators we see in San Lorenzo are mounted on original 1940s and 50s wooden swing gates whose fence posts were set directly into adobe clay, no concrete footing, no rebar, just a hole and hope. The East Bay’s moderate but wet winters saturate that clay and it shifts. The post leans. The gate’s swing arc changes. The operator’s limit settings, set for one geometry, now see a different one, so the motor reverses mid-travel or fights the gate until something gives, usually the battery or the board. On dry summer days the clay shrinks, the post tilts the other way, and the gate relaxes enough to seem fine again. That cycle does not show up in newer suburbs with concrete-set steel frames. It is a San Lorenzo pattern, block after block, and it is the first thing we check on any Ghost Controls call here.

On a recent job off Via Mirabel in the San Lorenzo Village tract, a homeowner’s Ghost Controls single swing operator kept reversing mid-travel after a winter storm. The gate looked straight at first glance. We found the original redwood gate had swollen and the clay-set fence post had leaned about an inch, enough to throw the limit switch off. We re-set the post in a proper concrete footing, rehung the gate, and recalibrated the operator. No control board replacement, no new motor. The gate has run through two more rain cycles since without a single reversal. Sometimes the cheap fix is the correct one, if you actually look.

For homeowners in San Lorenzo, this matters because a Ghost Controls operator is not a bad product. It’s usually a good product fighting a bad foundation. We fix the foundation, not just the symptom.

Ghost Controls Models & Products We Service in San Lorenzo

We work on Ghost Controls Heavy-Duty Single Swing operators like the TSS1, the Dual Swing Kit TDS2, slide gate operators like the TSL1, and the solar and battery backup systems that keep them running when PG&E cuts out. For critical electronics, control boards and motors, we use genuine Ghost Controls parts. For batteries and some hardware, we install high-cycle aftermarket components that meet or exceed OEM specs, because the aftermarket has caught up in those categories and the cost difference is real.

If your operator is older but the frame is sound, we repair it. If the board and motor are both failing on a discontinued model, we show you a like-for-like replacement rather than patching it twice and billing you each time. We stock common Ghost Controls boards and remotes locally so most San Lorenzo repairs don’t wait on a shipment.

Ghost Controls Service Pricing in San Lorenzo

FAQs – Ghost Controls Gate Repair in San Lorenzo

Service Areas Near San Lorenzo

We serve San Lorenzo service area plus Union City, Fremont, San Leandro, Newark, and Hayward. For Ghost Controls work further down the Peninsula, see Ghost Controls service in East Palo Alto and Ghost Controls service in Menlo Park. Same brand knowledge, same gate-only focus, wherever the job is.

Book Your Ghost Controls Service in San Lorenzo Today

If your Ghost Controls gate is reversing, dead, or just unreliable, call (833) 593-6430. We’ll give you a straight diagnosis and a written price before any work begins. Same-day service is available for most San Lorenzo repair calls.

Written by Gerardo Kendrick, Owner at Gate Repair Union City, serving San Lorenzo, Newark, and the East Bay.