Gate Repair in San Leandro - Same-Day Repair, Priced Before We Start

Fast, Reliable Gate Repair Across San Leandro

Gate repair in San Leandro usually comes down to one of two things: a gate that won’t swing cleanly or an operator that won’t move the gate at all. For homeowners across 94577, 94578, and 94579, we handle both. From original 1950s wrought-iron driveway gates near East 14th Street to wood privacy gates in the hills above Fairview, our Gate Repair team works on nothing else. If your gate is dragging, leaning, or stuck shut, call (833) 593-6430 and we’ll get a technician out to look at it.

Call (833) 593-6430

Why Gate Repair Union City Is San Leandro’s Preferred Gate Repair Company

We only do gates. That’s the whole pitch. No fencing side jobs, no general handyman calls, no split attention. Every truck carries gate hinges, post hardware, operator control boards, remotes, and welding gear. When we pull up to a home in San Leandro, we already know what we’re likely to find: original posts that have gone soft in the damp, hardware that’s been rusting in the marine layer, and a panel that hasn’t sat square in years.

Led by Gerardo Kendrick, our crew is trained on nine gate and operator brands including San Leandro systems running LiftMaster, Mighty Mule, FAAC, and BFT. That brand coverage matters on repair calls because we’re typically servicing the operator that’s already installed, not selling you a replacement you don’t need. We diagnose first, quote the work before starting, and don’t surprise anyone with the invoice.

Metal Gate Repair in San Leandro

Metal Gate Repair in San Leandro is rarely just a hinge swap. The city’s older tract neighborhoods off East 14th Street and around the downtown core have original driveway gate posts set only a foot or two into the ground instead of properly footed. Decades of fog-dampened soil movement leave them leaning, so the gate drags on the concrete apron no matter how much you adjust the hinges. A typical metal gate repair in San Leandro runs $225 – $475, with post-reset and re-footing work adding $180 – $350 when the lean is the root cause.

Hinge, Latch, and Post Reset

Steel hinges and latches corrode faster here than inland. Salt-laden air off the Bay coats hardware and seizes swing pivots. We cut off the old hardware, set a new hinge or re-foot the post, and re-align the panel so it clears the slab.

Weld and Rust Repair

Wrought-iron gates from the 1940s through 1960s pick up rust along the bottom rail and at welds. We grind, weld, and re-seal in the field. The goal is to keep the original gate, not replace a 60-year-old panel that just needs structural attention.

Wood Gate Repair in San Leandro

Wood Gate Repair in San Leandro follows a seasonal pattern tied directly to the fog belt. Wood swells in the wet winter months and binds against the jamb or drags on the driveway; by late summer it shrinks back and the hinges and latch loosen. On older ranch-style homes across 94577 and 94578, a typical wood gate repair runs $200 – $440. When the post itself has rotted at grade or leaned from shallow footing, expect $250 – $520 including post extraction and re-set.

Swell, Bind, and Latch Alignment

We trim moisture-swollen panels, re-align latch strikes, and swap hinges that have pulled loose from repeated seasonal movement. On a ranch-style lot off East 14th Street in 94577, our crew found an original wood swing gate on a narrow concrete driveway whose hinge post had leaned several inches after years of marine-layer damp – the panel was dragging the slab, not hanging. We pulled and re-set the post with a proper footing, corrected the sag, and swapped the swollen hinges and latch before re-checking alignment, and the gate swung clean again without touching the apron.

Rotted Post and Rail Replacement

Posts set in fog-dampened soil eventually rot below grade, even with treated lumber. We replace the post with a properly footed one rather than scabbing on a repair brace, then re-hang the gate so it operates cleanly year-round.

Trusted Brands We Service in San Leandro

We work on LiftMaster systems specifically, including residential slide and swing operators that fail at the control board, limit switch, or remote receiver, and we offer LiftMaster repair in San Leandro. Mighty Mule and Ghost Controls hardware shows up regularly on San Leandro driveway gates, and we carry compatible parts on the truck. For commercial and high-cycle systems, we’re trained on FAAC and BFT hydraulics and electronics. From the motor to the hinge, the repair comes down to knowing the exact system you own, not guessing at it.

Common Gate Repair Problems We See in San Leandro Homes

• Leaning original posts. Most 1940s – 60s gate posts around San Leandro were set only a foot or two deep. Fog-dampened soil shifts them over the years, so the panel binds and drags on flat concrete driveways. This is a post-reset job before any hinge work makes sense.
• Salt-air corroded hardware. Steel hinges, latches, and operator internals rust faster in San Leandro than they do inland. Swing gate pivots seize up and the operator burns itself out trying to move a gate the hinges won’t let move.
• Seasonal wood movement. Wood privacy and driveway gates swell in winter fog and bind against the frame. By late summer they shrink and rattle, loosening latches and hinges in the same spots every year.
• Operator failures on narrow driveways. San Leandro’s tract lots have tight concrete aprons and single-car widths. When an operator’s safety sensor misreads or a limit switch drifts, the gate stops mid-cycle on a driveway too narrow to walk around.

Pricing for Gate Repair in San Leandro, CA

We Also Serve Cities Near San Leandro

Our Gate Repair in San Leandro service area runs through San Lorenzo, the Fairview corridor, Union City, and into Fremont. If you’re just over the city line in any direction, call and ask, the odds are we already have a truck scheduled in your area this week.

FAQs About Gate Repair in San Leandro