Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in San Leandro, CA
Gate installation in San Leandro means working with 50 to 70 year old posts, narrow concrete driveways, and marine-layer moisture that never really leaves the hardware alone. We install driveway gates, pedestrian gates, and electric gate systems across the 94577, 94578, and 94579 ZIPs, and we do it as a gate-only company, so the crew that shows up carries gate parts, gate tools, and gate knowledge and not much else. If you need a gate quoted, call (833) 593-6430 and we will come measure it.
Why San Leandro Homes Are Different
San Leandro’s housing stock is dominated by post-WWII tract and ranch homes built from the late 1940s through the 1960s. That matters for gate work because the original gates on those homes were built for a different era: single-car-width driveway openings, narrow side yards, and posts that were often set only a foot or two into the ground. Homeowners in the 94577 and 94578 ZIPs especially have original wrought-iron pedestrian gates and wooden privacy gates that are now past the point where tightening a hinge buys more than a few months.
Then you add the fog belt. San Leandro sits directly under marine-influenced air off San Francisco Bay, so steel and iron hardware corrodes faster here than it does ten miles inland. Wood gates swell and bind through the wet winter months, then shrink and rattle in late summer when the air finally dries out. We see the same seasonal cycle on job after job: loose hinges in August, stuck gates in January, rusted latches all year. In the older tracts off East 14th Street and near downtown, the original posts have often leaned with decades of damp soil movement, which means the real repair is a post reset before any hinge or latch work even makes sense.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Main San Leandro Services
Most San Leandro homeowners call us for two things: a gate that will not open or close properly, and an electric gate that has stopped responding to the remote or keypad. Both are covered below with dedicated pages for this city.
Gate Repair in San Leandro
Mechanical gate repair here is rarely just a hinge swap. The typical San Leandro job involves a sagging wooden or iron gate, a post that has shifted in damp clay soil, and a latch that no longer lines up because the whole assembly has moved over decades. On 94579 properties near the bay, we commonly find corroded steel hardware that has to be cut off rather than unscrewed. We repair the gate, reset or reinforce the post as needed, and adjust the swing so the gate clears a flat concrete driveway instead of dragging across it. See how we handle this work at Gate Repair in San Leandro.
Electric Gate Repair in San Leandro
Electric gate systems in San Leandro take extra abuse from marine air, which corrodes control board connections, receiver terminals, and safety sensor housings. We diagnose motors, boards, remotes, keypads, and safety loops on LiftMaster, FAAC, BFT, Viking, and other major systems. When a San Leandro homeowner tells us the gate opens but will not close, the culprit is usually a misaligned or corroded safety sensor, not the motor itself. Our electric gate page covers the repair process in detail: Electric Gate Repair in San Leandro.
Gate Installation in San Leandro
Most San Leandro gate installations start with the same conversation: the old gate is original to a 1950s or 1960s tract home, the posts have leaned, and the homeowner wants something that will not need constant attention. The job often includes removing the old gate and posts, pouring proper footings for new posts, and setting a gate that will clear a flat concrete driveway without dragging. Because of the marine layer, we recommend hardware and finishes that hold up to salt-laden damp air, because hardware that works fine in Fremont or Union City can rust out quickly in the 94577 and 94578 ZIPs. We install both manual and automated systems, and we handle the full scope from post to motor. See more at Gate Installation.
Automatic Gate Installation
Signs you need it
You are opening and closing a driveway gate by hand every day, or you have a manual gate on a property where delivery drivers, tenants, or family members constantly leave it open.
What it costs in San Leandro
Automatic gate installation in San Leandro typically runs $4,500 to $11,000 depending on operator type, gate weight, and whether power needs to be run to the post.
How we do it
We measure the gate and opening, set or reinforce posts to hold the operator, run power and low-voltage wiring, mount the arm or slide operator, then program remotes, keypads, and safety sensors.
Electric Gate Installation
Signs you need it
You are installing a gate from scratch and want it automated from day one, or you have an existing gate that needs an operator, receiver, and safety loop added.
What it costs in San Leandro
Electric gate installation in San Leandro typically falls between $3,500 and $9,500 depending on whether the gate itself is new or you are adding automation to an existing gate.
How we do it
We install or retain the gate, mount the operator (arm, slide, or jackshaft), wire the control board and safety edges, then test the full system through open, close, and obstruction cycles.
Driveway Gate Installation
Signs you need it
Your existing driveway gate drags on concrete, the posts lean, or you want a wider opening than the original 1950s single-car width.
What it costs in San Leandro
Driveway gate installation in San Leandro typically runs $2,500 to $8,000 depending on gate width, material, and whether automation is included.
How we do it
We remove the old gate and posts, dig and pour new footings, set plumb posts, hang the gate with adjustable hinges, and verify the swing clears the driveway at every point.
Sliding Gate Installation
Signs you need it
You have a driveway with limited swing room, a steep approach, or a commercial entrance that needs a cantilever or track-style sliding gate.
What it costs in San Leandro
Sliding gate installation in San Leandro typically runs $3,000 to $10,500 depending on track versus cantilever design, gate length, and motor requirements.
How we do it
We set the track or cantilever rollers, fabricate or assemble the gate, mount the motor, and run the safety loops and sensors so the gate reverses on obstruction.
What Gate Installation Costs in San Leandro
| Item | Typical range in San Leandro |
|---|---|
| Standard driveway gate, new posts, no automation | $2,500 – $8,000 |
| Automated driveway gate with operator | $4,500 – $11,000 |
| Electric gate system, automation only on existing gate | $3,500 – $9,500 |
Do I need a permit to install a gate in San Leandro?
Most residential gate installations in San Leandro do not require a permit if the gate is under 7 feet tall and you are not altering the driveway approach or adding a motor with new electrical service. If you are adding a dedicated circuit for a gate operator, the electrical portion may need a permit. We check the current city requirements on every job before we quote.
How long does gate installation take in San Leandro?
Most standard driveway or pedestrian gate installations in San Leandro are completed in one to two working days, depending on whether old posts need to be dug out and new concrete footings need to cure. Automated systems add time for wiring and programming, and we coordinate that so the gate works the same day the operator goes in.
Brands We Service in San Leandro
We work on Mighty Mule and Ghost Controls systems commonly found on San Leandro residential gates, plus LiftMaster, FAAC, BFT, and Viking on commercial and higher-end automated gates. Because we only do gates, our trucks carry the boards, remotes, and hardware for these systems rather than ordering parts every time. See our brands.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in San Leandro, CA
| Service | Typical range in San Leandro |
|---|---|
| Gate repair, minor (hinge, latch, alignment) | $180 – $500 |
| Gate repair with post reset | $500 – $1,400 |
| Wood gate repair (sagging, rot, hardware) | $250 – $750 |
| Electric gate diagnostic | $100 – $250 |
| Electric gate board or receiver replacement | $300 – $900 |
| Electric gate motor replacement | $550 – $1,700 |
| Driveway gate installation, no automation | $2,500 – $8,000 |
| Automatic gate installation | $4,500 – $11,000 |
| Sliding gate installation | $3,000 – $10,500 |
What pushes a San Leandro gate job higher than a comparable job elsewhere is usually the post condition. Undersized posts set shallow in damp clay soil have moved over decades, and resetting them properly means digging, pouring, and bracing before the gate itself is even touched. The price you are quoted is the price you pay, and we confirm it in writing before any work starts.
Neighborhoods We Serve in San Leandro
We cover all of San Leandro, including the older tracts where original gates are the norm. We typically run calls across the city in a single day, with response times depending more on the job load than on which ZIP you are in.
- Downtown San Leandro
- Estudillo Estates
- Davis Tract
- Heron Bay
- Mulford Gardens
Service Area – Cities Near San Leandro
Gate Repair Union City also serves the communities around San Leandro, including San Lorenzo, CA to the south, Fairview, CA just to the east, Union City, CA across the 880 corridor, and Fremont, CA further down the East Bay. If you are on the edge of San Leandro, call us and we will confirm coverage.
Serving San Leandro, CA – Our Local Coverage Area
We’re based in the San Leandro area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in San Leandro
Yes. We cover residential and commercial gate work across the 94577, 94578, and 94579 ZIPs, from the downtown core to the bay side. We do not route San Leandro work through a general dispatch; a gate tech handles the call from start to finish.
If your property is in an HOA, especially in the newer developments around Heron Bay, you should check the governing documents before changing a gate that faces the street. Many San Leandro HOAs regulate gate height, material, and color. We can provide the dimensions and product details your HOA will ask for.
We schedule San Leandro jobs based on the same week or early the following week in most cases, and we send confirmation with the arrival window the day before. If you have a gate stuck open or a security concern, let the office know when you call and we will treat it as a priority.
If your San Leandro gate is sagging, stuck, or completely stopped responding, call (833) 593-6430 for a free estimate. We work on gates only, and we fix them from the post to the motor.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically within 30–60 min.
- 4You approve before work beginsNothing starts until you say go.
What San Leandro Customers Say
"Gate works properly now and the price was fair. The one thing is that it took two visits, because the operator model we have is old and the part had to be ordered. They didn't charge for the second trip."
- Cole Mercer"Gate stopped halfway and sat there for two days blocking the driveway. He found a dead capacitor in the operator, had one with him, and we were moving cars again in under an hour."
- Heather Thompson"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
- Amanda Quinn